Search results

Hi Bellancaneers, I have a 14-13 that is supposed to have been converted to a 14-13-2. The club does not have the drawings needed to verify this. I do not have any logbooks, either. I previously requested for someone to please send me the length of a 14-13-2 horizontal stabilizer. My AI says...

Hi Guys, I have a 1946 Bellanca 14-13 that is supposed to have been converted to a 14-13-2. I believe it has but, I can't prove it yet. The log books are reported to have been destroyed, and there is no mention of the conversion in any of the OKC paperwork. The necessary drawings to verify it...

Hi guys, I need a source of supply for the Franklin 165 H.P. Intake, Exhaust, and Accessories mounting gaskets. Does any such place still exist, or do I need to buy the Top Overhaul Kit ? Thanks in advance. Dick N29TJ

Hi Gang, I need a source for the purchase of a new, overhauled, or a repair kit for the Bellanca-Franklin mechanical fuel pumps. Thanks. Dick N29TJ

Hi Gang, I have a question for you. The logs were lost for my Bellanca 14-13-2 project. I finally received copies of the Oklahoma City Records (160 pages). One of the 337's states that an electric hydraulic landing gear system has been installed, similar to the Viking 17-30. It gives part...

Hi Gang, Does ayone have the ordinates for the Bellanca "B" Airfoil ? You can contact me off the net if you so desire, at dcgoff@webtv.net. Thanks. Dick Goff N29TJ

Hi All, Since my levelling pins have been ground away, does anyone know what the factory used to level the aircraft, to "level" the levelling pins? Thanks. Dick N29TJ

Hi All, Doe anyone have the criteria, or info, necessary to determine the proper rib stitching for the tail surfaces on my 14-13-2. I don't mean the spacing. How much do you pull the fabric down towards the rib, at the leading edges. Do you pull the fabric all the way down to the rib with the...

Does anyone have the dimensions for the engine mount to firewall bolt holes for a 14-13 with a Franklin 165? I really have to force the mount for the top 2 holes. The bottom holes are off by 3/8". I can't see any physical damage to either unit. Any reccommendations ? Dick N29TJ

The leveling pins have been ground away on my 14-13 project. Where is another suitable location to use for leveling the aircraft? Thanks in advance. Dick #N29TJ.

Hi All, In a previous post, I described a hydraulic gear conversion in a 14-13 and requested if anyone had any knowledge of it. I have since found the following: The hyd unit was manufactured by Prestolite, part# 105476, and is for 12 volts. The following numbers are stamped on the bottom...

Hi Folks, I just got my 1946 Bellanca 14-13 project home Friday (5th).I was told it has the -2 tail, and the -3 hydraulic gear. Unfortunately I did not get the log books, so don't know for sure. The approximately 6x6x3(?) hyd unit sits under the passenger seat with a small electric motor...